The fix of this bug has been committed, however, some parts of this issue still exist after fix committed. Related blueprints Enable Ethernet on all Builds. Works out of the box. A bit is 8 times smaller than a byte. Current asix seems not stable.
| Uploader: | Tukinos |
| Date Added: | 6 November 2009 |
| File Size: | 20.11 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 89099 |
| Price: | Free* [*Free Regsitration Required] |
When I need to convert between units I use this tool here: Issue as described by comment 34 still happening with the In order to run without the module “cfg I tried disable and enable the Ethernet, but the browser still can’t show the web page.
Well, back to the drawing board. The only problem is that the speed you get is not the best it could offer, as the ethernet usb device acts as a usb 1. As distributed with Zenbook Ultrabooks.
MCS – USB to Dual Serial Controller | ASIX
Contents 1 General remarks 2 Compatible devices 2. The driver for the chipset Asix AX included with the Raspbian kernel v 3. I also tried the “alip-n- tar 0. Avoid using this protocol unless you have no better options.
Works very well on a Raspberry Pi 2 running Raspbian Other bug subscribers Subscribe someone else. The ECM has been show to work on every other target. You can find the kmsg and logcat output in attachment.
MCS7720 — USB 1.1 to Dual Serial Controller
I tried “rmmod cfg Please see the below. I’ll post if it works well.
Retrieved from ” tehernet AX chipset using the asix kernel driver. I had it plugged into a powered hub so I cannot say if it works connected directly to the pi. See this thread about using the. I need to pick one which is supported by our current kernel.
Tony Mansson tony-mansson wrote on Needs its own power source. However, when I attempt an iperf to test the speed I get 3.
Driver – Adapter / Converter
Then we can make a test and comparison. On the other hand, do check before you reboot, it might already be working, as per “rtl” support above. Currently, the module “cfg Reboot and you should have a etehrnet working Ethernet adapter. Cable Matters USB 3.
RPi USB Ethernet adapters –
Works out of box very stable with asix kernel driver on latest raspbian 3. The USB host runs “usbnet”and the other end of the link might be: In addition, the only etherhet that truly appear to be 2. This means that even if a particular model is known to be compatible, this might not apply to the unit you have acquired.