E-9 Paper jam when the power switch is turned on. Pull the left cover downward to remove the 3 hooks at the top. Sleep mode The heater mode is turned off when a sleep mode command is received from the controller. OPC drum, toner cartridges, image transfer belt unit and fusing unit. The speeds of the transport motor Ml and fusing drive motor M4 are switched from 60 mm 2. Yes Replace the timing roller solenoid SL5. Paper exit roller for each bin 4.
| Uploader: | Samut |
| Date Added: | 2 October 2004 |
| File Size: | 59.38 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 55921 |
| Price: | Free* [*Free Regsitration Required] |
Remove the top cover.
Printer: Minolta magicolor DL | OpenPrinting – The Linux Foundation
The pin positions are to be aligned when reassembling. Replace the fusing unit. The speed most suitable for the type of ams is selected to achieve optimum fusing.
Do not forget to mount the reinforcement plate when reassembling the printer.
Laptops by Dan Ackerman Nov 26, Only print envelopes via the multipur- pose tray. Transport motor Ml 2.
Remove maglcolor 1 set screw for the paper take-up section cover. Remove the 2 set screws for the suction fan. C Developing The toner is applied in an even thickness to the developing roller by the toner controller plate, the toner is then applied to the electrostatic latent image on the OPC drum, and finally the toner image is developed.
Remove the 1 mounting screw for the rack turning knob and remove the turning knob.
Minolta-QMS Magicolor 2200 EN – printer – color – laser
Remove the 2 fusing contact motor set screws. Remove the 2 screws for the duplex unit and remove it from the main printer unit.
No Install recommend paper. Environmental requirements The printer has the following operating environment requirements: Mailbin Power Off Power cord improperly connected.
Yes Replace the image transfer roller pressure sensor. Use of controls, adjustment or performance of procedures other than those specified in this manual may result in hazardous radiation exposure. Doing so could result in an electric shock. Remove the 1 set screw mimolta the transport paper sensor and 1 con- nector. Check Result Corrective action 1.
MINOLTA-QMS Magicolor 2200 DP Maintenance Manual
No Replace the gears for the one-way clutch. Remove the 1 connector for the fusing fan and the 2 set screws. OPCdrum Creates the toner image. Don’t have an account? Yes Replace the belt minola release sensor.
Remove the toner cartridge rack 1 Remove the rear cover. Place circuit boards in a conductive bag or case, or wrap them in aluminum foil. Paper detecting sensor Detects paper that has been sent to the duplex unit. Best Cyber Monday deals at Staples: The test will run until paper is consumed, printer turned off, or paper jam occurs.
Max Media Size Custom. Remove the lower paper take-up guide. Don’t show me this message again.
Be respectful, keep it civil and stay on topic. Since radiation emitted inside the LBP printer is completely confined within protective housing and external covers, the laser beam cannot escape from the LBP printer during any phase of user operation.
