If the address is acceptable to you then skip to section about Configuring the Computer for work with the Ethernet card. Configuring the Printer in Windows You need to make a few changes in the printer settings to get it to work with the Ethernet adapter. In my case, I used Make sure you line up the black card plug with the black socket inside the printer. To find out more, including how to control cookies, see here:
| Uploader: | Shaktigor |
| Date Added: | 15 April 2006 |
| File Size: | 64.11 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 93208 |
| Price: | Free* [*Free Regsitration Required] |
If you would like to register as an Epson partner, please click here. For example of the adapter shows an IP address of If this happens, cycle power, and wait for the Green LED to start blinking. The printing port of the driver on the computer side is not specified correctly. You may need to make a few changes in the printer settings to get it to work with the Ethernet adapter.
Turn the printer off.
Q: How to check the IP and MAC Address of the Epson Printer? : Support Group
Fasten the two mounting screws through the faceplate of the new interface. Mine looked like this: Confirm the connection of the power supply unit or the voltage of the commercial power. What’s in the box.
Email netwrk Address never made public. These numbers are important when configuring the adapter- It is advisable to make a note of these values in a secure place. Space-saving and versatile, it has a footprint of just W x D x H mm, and can also be wall-mounted. Take a small screwdriver or ball point pen and for a slow count to three, press on the button in the little hole on the elson port plate also circled in red.
Run the printer self test hold down the feed button while turning on the printer. Power the Printer up, with Ethernet Module installed. To use this setup set the IP address of the computer and the printer statically, both in the same sub domain, with different addresses.
You can reset the Ethernet card to it’s default settings by placing a small jumper across two pins while power cycling the card. Good luck and thank you Mark and Steve!
We epdon recommend this be changed. You should see a screen similar but not identical to this: Connect a computer directly to an Ethernet printer using a crossover cable.
How to configure an Epson TM-U220 printer with ethernet to be used with the Dominos Pulse system
The default password for the interface is Epson. Run a configuration report.
The printer is not online in Windows. Get the initial settings of the Printer Run u20 printer self test hold down the feed button while turning on the printer.
Epson TM-UB (BC): Ethernet, PS, EDG – Epson
IP address setting is not correct. To find out more, including how to control cookies, see here: Assuming you have a successful printout of the default factory settings, you are ready to complete the final steps:.
A older, cheaper or gigabit newer ethernet switch and two ethernet cables. Remove the existing interface board from the printer by unscrewing 2 screws. The ‘Submit’ button with write settings to the printer.
How to connect an Epson POS Printer with an Ethernet Adapter
If nothing prints, then turn off the printer and make the following changes to Y220 Don’t forget to make the same changes on the computer side to maintain connectivity. This special cable allows you to bypass using a router or switch to connect a computer to a printer for testing.
Do not use more than one printer with the Ethernet adapter on the same network without changing the IP address. If changing a printer to Ethernet you must change the specific dip switch on the Epson printer to allow for the Espon card.